Turbo Drive for Manual Mills

[Home][What's New][Products & Services][Feedback]

Quick Reference

POWER UP & OPERATING PROCEDURES

  1. Turn (Control On/Off) switch on bottom housing to ON
  2. Press (Faster) to increase speed to 20 ipm.
  3. To set right limit: Hold down > + (Set Limits) at the same time. Limit is set when you release the > Key
  4. Press the < to move back to zero (where the left limit is until you move it).
  5. To set left limit:
  6. Hold down < + [Set Limits] at the same time.
  7. To set Zero position: Move to point. Press [Stop]. Then press [Zero].
  8. Set desired feed rate and begin cutting.

 

Manufactured in the USA

SERVO PRODUCTS COMPANY

433 N. Fair Oaks

Pasadena, CA 91103 USA

For more information Email denver@corrick.com

Turbo Drive | Home Page

Send mail to denver@corrick.com with questions or comments about this web site.
Last modified: January 13, 1999